Tools Needed:
Flat head Screwdriver
Adjustable Wrench
The machine should be unplugged and cool to the touch before you begin.
Remove and set aside the cup warming tray and water reservoir.
Remove the 5 Phillips screws (2 on each side and 1 on the back) and then slide the body panel off of the machine:
If removing the Z-Panel is necessary continue with the following steps.
Disconnect the wires from the power supply socket. Note where each wire is connected to ensure they are properly positioned when reconnected. (Pro Tip: Take a photo of the power supply socket for reference). If needed, use a Flathead Screwdriver to pry the wires off the back of the socket.
2. Use a Phillips screwdriver to remove the 2 Z-Panel screws and use an adjustable wrench to remove the nut from the expansion valve.
3. Lift the Z-Panel off and set it to the side.
You've successfully removed the panels from your LUCCA Solo! To reinstall the panels, simply follow these instructions in reverse order.