Getting Started

Breville Oracle Touch: Setup Guide

Congratulations on your new Breville Oracle Touch! In this guide, you should find everything you need to set up and operate your dual-boiler espresso machine.

Step 1: Unboxing and Inspection

  • Remove the machine from the box and place it on a stable, level surface.
  • Before turning on the machine, inspect for damage that may have occurred during shipping. If you notice any damage, contact us immediately.
  • Please note that it is normal for a small amount of water to be on the machine when it arrives. It is also normal for the portafilter to not fit perfectly at 90 degrees!
  • Save all packaging, as this is needed for returns and repairs.

Step 2: Water quality

  • Before introducing water to your machine, it's essential to test it to ensure it's adequately soft, around 50 ppm (parts per million). Use the included water test strips from your home barista starter kit to verify the hardness of your water. To learn more about our recommendations for water quality, check out our blog post, The Importance of Water and Your Espresso Machine.
  • Once you've confirmed your water quality is adequate, fill the water reservoir (see the manufacturer's manual, page 10, for details). Note: Do not use Zero water or reverse osmosis, as the machine will not register that the reservoir has been filled.

Step 3: Turning on and operating your machine

  • Your machine is set for use on a 110v outlet. Plug your machine directly into a grounded socket (do not use an extension cord) and turn it on by using the ON/OFF button on the front panel.
  • For step-by-step instructions on how to set up and operate your machine, see the manufacturer's manual

Additional Resources: