You'll need:
- 2mm allen key
First, you'll need to remove your panels.
The magnet sensor is located on the panel in back of the water reservoir, so remove the reservoir.
Using the 2mm allen key, remove the two screws fastening the magnet sensor to this panel. Warning: There are two nuts on the back side of this panel, so keep a hand on the back to avoid losing them.
Once the screws are removed, pull the sensor out.
There are two wired connections that you'll need to remove.
A helpful trick to get the spade connectors disconnected: Use a small flathead screwdriver or pick to pry the plastic cap off of the metal connector.
Once both wires are disconnected, pull the magnet sensor free.
Replace the magnet sensor by following these steps in reverse order.
If you have any questions, feel free to contact us at [email protected]