This quick-start guide will walk you through setting up your grinder. Check the product page for a list of included accessories, details, and specs. See the User Manual for information on operating the grinder and for additional resources.
Step 1: Out of the box and onto the counter
Remove the grinder from its box and place it on a solid, level surface.
Inspect the grinder for any damage. If you notice any, contact us immediately.
Place the hopper into the grinder, and if you wish, attach the bellows and the grinder lid.
Installing the Dosing Cup Rest
Your dosing cup rest comes with two screws: one long and one short.
Raise the lever. Make sure the lever is in the up position before you begin, and leave it there until you install the rest.
Remove the existing screw under the chute. Beneath the chute, you’ll find a small black half-circle piece held in place by a single screw. Unscrew it and set that original screw aside, since you won’t need it.
Attach the top of the rest with the long screw: Line up the dosing cup rest with the half-circle piece still in position, then thread the long screw into the hole you just emptied.
Secure the bottom with the short screw and thread the short screw into the lower mounting hole.
Tighten both screws until the rest sits firmly with no wobble, and be careful not to overtighten.
Close the rotating metal tab before adding coffee to the hopper.
Step 2: Operating your grinder
Plug in your grinder.
The power switch is on the right side of the chassis.
The quick activation switch is conveniently located next to the dosing cup holder for quick, intuitive activation. This lever slides up and down to engage the motor
With the metal tab closed, add coffee beans to the hopper, then press the quick activation switch down to start grinding.
With coffee in the hopper and the motor running, open the tab, allowing the coffee to grind into the dosing cup.
Close the metal tab and use the blow-up hopper to push any remaining grounds through the burr chamber.
Once your coffee dose is ground, push the quick activation lever back up.
Step 3: Dialing in your grind
Adjust the grind setting by turning the large dial on top of the grinder. The grinder is infinitely adjustable, with up to 20 settings, and the revolution counter serves only as a reference when you're using the grinder for espresso or other brew methods. Turning the dial clockwise (toward smaller numbers) makes the grind finer, and turning counter-clockwise (toward larger numbers) makes it coarser. When dialing in for espresso, make small adjustments, in increments of 1/4 - 1/2 a number at a time, as this mechanism is very sensitive.
Note: If you adjust the dial in the fine direction more than 2 numbers at a time, the grinder may jam.
Using the grinder for drip coffee and pour-over will require a large adjustment, likely an entire 360-degree rotation or two. When moving from espresso to pour-over (e.g., fine to coarse), it is okay if the grinder isn't running. When making large adjustments back to espresso (e.g., coarse to fine), it's best to run the grinder so it doesn't jam.
If coffee doesn't come through the grinder at any point, the setting may be too fine or the burrs may be jammed. Open the burrs to free the coffee by turning counter-clockwise, then make the setting coarser.
For help dialing in your grinder for the perfect shot, check out our article How to Dial In Your Espresso Grinder. For help pulling great shots, check out our Espresso 101 section to learn how to pull shots, steam milk, and more!
