-
Getting Started
-
Espresso 101
-
Warranty, Ordering & Returns
-
Bezzera BZ10
-
Bezzera Duo DE
-
Bezzera Duo MN
-
LUCCA A53 (Direct Plumb & Mini) by La Spaziale
-
LUCCA M58 by Quick Mill
-
LUCCA S58 by Profitec
-
LUCCA X58 by Quick Mill
-
La Marzocco Linea Mini
-
La Marzocco GS3
-
Lelit Bianca
-
Lelit Elizabeth
-
Lelit Victoria
-
ECM Synchronika
-
ECM Special Edition Classika PID
-
ECM Mechanika V Slim
-
ECM Casa V
-
ECM Puristika
-
Profitec Pro 300
-
Profitec Pro 400
-
Profitec Pro 500
-
Profitec Pro 600
-
Profitec Pro 700
-
Profitec Pro 800
-
Rocket Appartamento
-
Rocket R58 / Cinquantotto
-
Rocket Giotto
-
Rocket R Nine One
-
La Spaziale S2 EK
-
Rancilio Silvia
-
Rancilio Silvia Pro
-
Rancilio Silvia Pro X
-
Izzo Alex Duetto
-
Quick Mill
-
Breville Oracle
-
Dalla Corte Mina
-
Slayer
-
Lucca Grinders
-
Baratza Grinders
-
LUCCA Atom 75
-
Eureka Grinders
-
ECM Grinders
-
Compak Grinders
-
Fellow ODE Grinder
-
Mahlkonig Grinders
-
Profitec Grinders
-
Breville Grinders
-
Dalla Corte Grinders
-
Macap Grinders
-
Fiorenzato Grinders
-
General Troubleshooting
-
Like New & Trade-In Program
-
Eureka Mignon Libra
-
Eureka Mignon Libra User Manual
-
Rocket Boxer Setup Guide
-
Rocket Boxer Timer User Manual
-
Baratza Encore ESP Setup Guide
-
Baratza Encore ESP User Manual
-
Fellow Opus User Manual
-
Fellow Opus Setup Guide
LUCCA A53 / Vivaldi: Cleaning the Flow Meter Gicleur
Below you will find instructions on how to check and clean the flow meter gicleur in your La Spaziale LUCCA A53 or Vivaldi espresso machine. (Difficulty ☕☕☕)
Before you begin, shut off the water line, turn off the machine and allow it to cool down first.
Tools Needed:
- Phillilps screwdriver
- 17mm wrench
1. Remove the lower front panel of the machine and take out the drip tray. You can remove the panel by taking out the two screws holding it in place, and pulling it out by the bottom of the panel.

2. Remove the larger, 17mm fitting from the flow meter outlet. Inside will be a small screen with the gicleur sitting on top of it. Remove the gicleur from the fitting/copper pipe.

3. Ensure the small opening in the gicleur is clean and free of blockage. Reinstall with the small end up, and the larger end flat on the screen. The small end will fit inside the copper tube as you tighten down the nut to the fitting.
