LUCCA X58: How to Replace the PID

Need to replace the PID on your LUCCA X58? Follow the steps listed below.

Tools needed:

- Philips head screwdriver

- small flat head screwdriver 

1. Remove the panels.

2. Locate the PID - (same side as the steam wand) 

3. Remove the screws that hold the PID to the frame:

4. Take a photo - or use this photo for reference - to know where the electrical connections go on the back of the new PID. Unplug the electrical connections on the back of the old PID and remove:

**The gray/green/brown wire just disconnects from the back of the shot timer:

**Use a small flat head screw driver to remove the electrical pins (remember what order they go in.)**

5. Take the new PID, reinstall the electrical connections (using photo in step #4 for reference) and line the new PID with the holes on the side of the machine. 

Pro tip: Only partially screw in the PID - make sure the PID looks straight from the front - then with one hand holding the PID in place, secure the screws into place.  

6. Leave the panels off and turn on the machine to test!