Profitec Move: Draining Instructions

This article shows how to drain the boilers of a Profitec Move that can fully heat.

*If you need to drain the boilers of a Profitec Move that is unable to fully heat follow these instructions* (Link to No Heat Instructions)

Tools Needed:

• Measuring Cup or Pitcher
  
  

Steps:

1. Turn on the Profitec Move and allow it to fully heat.
2. Place the measuring cup or pitcher below the group head and press one of the brew buttons to activate the pump.
   
   
   
3. While the pump is running, lift the water reservoir out of the back of the machine and set it aside. When water stops dispensing from the group head turn the machine off. Approximately 1 cup of water should be dispensed from the group head.
   
   
   
4. Place the measuring cup or pitcher below the hot water tap and open the valve. Allow water to dispense into the vessel until it stops. Approximately 1-2 cups of water should be dispensed from the boiler. Close the valve.