Lelit Mara X: SSR Replacement

Follow these instructions to replace the SSR in your Mara X.

Tools Needed:
- #2Philips screwdriver
- 7mm socket or hex nut driver
- Small adjustable wrench

NOTE: The machine should be unplugged and cool to the touch before you begin.

1. Start by removing the panels from the machine.

2. Identify the SSR bracket attached along the left side of the machine.

2. Unscrew the Philips head screw holding the SSR bracket in place, then remove the bracket from the machine.

3. Take note of which wires go where, then disconnect the wires from the SSR. 
(You can refer to this photo later when installing the new SSR.)


4.Use the 7mm socket to remove the retaining nuts holding the SSR to the back of the bracket posts. Dismount the faulty SSR and discard it — don't get it confused with the new SSR!

5. Install the new SSR by following these directions in reverse.