LUCCA X58: Draining the boiler (No heat)

If you need to drain the boiler of your X58, but your machine will not heat, or has a blockage, use these instructions to drain your boiler manually.

Tools Needed:
-Philips head screw driver (Panel Removal)
-17mm crescent wrench x2
- 5 gallon bucket or large bowl
- Towel(s)


Remove the panels from the machine.

1. Identify the copper tube connecting the boiler to the steam wand. You will need to use two 17mm crescent wrenches, one to hold the steam assembly in place, and the other to unscrew the brass fitting on the copper tube.

2. Next, you will need to loosen the lower brass nut, and turn the now loose pipe facing up and out of the machine.

3. You will need to retighten this fitting now that it is facing upward. This will be used as a makeshift drain port for your boiler.

4. Please use caution for this next step! Pull your machine forward to the end of the bench or counter and turn it over on its right side over a bucket. You will need to hold onto the top panel while you flip the machine to finish draining. Use a towel to dry any errant water. 

5. To reassemble follow these instructions in reverse order, don't forget to tighten every fitting!