Getting Started

Profitec Pro 700: Setup Guide Video

Congratulations on your new Profitec Pro 700 Espresso Machine. Watch our setup video below on this dual boiler, E61 espresso machine to help you get started.

Step 1: Inspect the box and the machine for damage

  • Remove the box from the machine and set it on a stable and level surface.
  • We recommend saving all of the packing materials.
  • Inspect the machine for damage.
  • If you find any damage, please contact us immediately.
  • Once you’re done inspecting the machine, remove the wing-nuts from the bottom of the machine.
  • These hold the pump secure for shipping, and would amplify the sounds of the pump when it’s in use.

Step 2: Choosing your water source

  • The Profitec Pro 700 can use either the built in reservoir or a plumbed-in line.
  • If you plan on using the reservoir, make sure the water source knob underneath the machine is in this position and the water source switch under the drip tray is set to reservoir.
  • If you prefer to plumb-in your machine, turn the water source knob to this setting, and change the water source switch to the plumbed-in setting.
  • Before introducing any water to the machine, it’s important to test it to make sure it is adequately soft
  • Use the included water test strip to verify the softness of your water. Ideally, we’re looking for a softness below 50 ppm.
  • Please read The Importance of Water and Your Machine to learn more about our recommendations for water quality.

Step 3: Adding water and filling your boilers

  • For reservoir use, fill the reservoir with filtered and adequately soft water.
  • Lift the brew lever and turn the machine on.
  • With the brew lever up, the pump will activate and water will start to fill the steam and brew boilers.
  • After a short period, you’ll start to see water coming through the group head.
  • Lower the brew lever once 4 ounces of water has been dispensed from the machine.
  • Remove the drip tray and turn the steam boiler switch to the on position
  • For plumbed-in use, attach the included braided line to the direct water inlet on the bottom of the machine.
  • To attach, simply screw on the line until hand tight, then use an adjustable wrench to tighten an additional quarter turn.
  • Attach the other end of the braided line to a cold water source.
  • Open your water line and check for leaks.
  • If there are no leaks, lift the brew lever and turn the machine on.
  • This will activate the pump and fill the brew and steam boilers.
  • After a short period, you’ll start to see water coming through the group head.
  • Once 4 ounces of water has been dispensed from the machine, lower the brew lever to turn off the pump.
  • To activate the steam boiler, turn on the steam boiler switch located behind the drip tray.
  • At this point, your setup is done. All you have to do is wait for the machine to come to temperature, and then you’ll be ready to pull your first shots.

Helpful Links